武林飞鸽品牌营销中心

在线服务
线上经验丰富团队
注重口碑
客户第一 用心服务
性价比高
让利客户 创造价值

欢迎来电:

0571-89266809

企业动态

手动葫芦维护操作手册

2014-01-25

Manually Hoist

 

Maintenance Manual

 

 

维护方法

 

Maintenance methods

 

1.

使用完毕应将葫芦清理干净并涂上防锈油脂,存放在干燥

地方,防止手动葫芦受潮生锈和腐蚀。

 

Hoist clean up after use and should be coated with anti-rust oil,stored in a

dry place,moisture to prevent rust and corrosion chain hoists.

 

 

 

手动葫芦

 

2.

维护和检修应由较熟悉葫芦机构者进行,用煤油清洗葫芦

机件,在齿轮和轴承部分,加黄油润滑,防止不懂本机性能原理

者随意拆装。

 

Maintenance and repair should be more familiar with hoist bodies were

carried out Mechanical cleaning hoist with kerosene, Gears and bearings in

part,Add Huangyou Run slip,Prevent those who do not understand the

principle of free disassembly machine performance.

 

3.

葫芦经过清洗维修,应进行空载试验,确认工作正常,制

动可靠时,才能交付使用。

 

After cleaning maintenance hoist,Load test should be carried out,Confirm

working properly,Braking and reliable, theBe delivered.

4.

制动器的摩擦表面必须保持干净。制动器部分应经常检

查,防止制动失灵,发生重物自坠现象。

 

Brake friction surfaces must be kept clean.Brake parts should be

inspected regularly,Prevent brake failure,Place heavy objects from falling

phenomenon.

5.

手动葫芦的起重链轮左右轴承的滚柱,可用黄油粘附在已

压装于起重链轮轴颈的轴承内圈上,再装入墙板的轴承外圈内。

 

Around the sprocket Manually hoist lifting the ball bearing,Butter has been

pressed in adhesion can be installed on the lifting sprocket bearing inner ring

on the journal,Load bearing wall and then outside the circle.

 

6.

手动葫芦在安装制动装置部分时,注意棘轮齿槽与棘爪爪

部啮合良好,弹簧对棘爪的控制应灵活可靠,装上手链轮后,顺

时针旋转手链轮,就将棘轮、摩擦片压紧在制动器座上,逆时针

旋转手链轮,棘轮与摩擦片间应留有空隙。

 

Manual hoist brake part of the installation,Note with the pawl ratchet claw

alveolar Department of meshing well Spring on the pawl control should be

flexible, reliable,Sprocket to get started after installation,Clockwise bracelet

round,Will ratchet, pressed the brake friction plate seat,Counterclockwise

rotation bracelet round,Ratchet and friction plate should be left between the

gap.

7.

为了维护和拆卸方便,手链条其中一节系开口链(不允许

焊死)。

 

In order

to maintain and facilitate

the demolition,

hand chain in whic

h a

series open-chain (no welded).

 

 

8.

在加油和使用手动葫芦过程中,制动装置的摩擦面必须保

持干净,并经常检查制动性有,防止制动失灵引起重物自坠。

 

In

the

refueling

process

and

the

use

of

manual

hoist,Brake

friction

surfaces must be kept clean,And

regular inspection of braking there,Prevent

brake failure caused by heavy objects from falling.

 

使用规则

 

Use Rules

 

1.

严禁超载使用。

 

Overloading is strictly prohibited to use.

 

2.

严禁用人力以外的其他动力操作。

 

Prohibited use of human power other than the operating

 

3.

在使用前须确认机件完好无损,传动部分及起重链条润滑

良好,空转情况正常。

 

Before Use, be sure that parts intact,Transmission parts and lifting the

chain oiled,Idling situation to normal.

4.

起吊前检查上下吊钩是否挂牢。严禁重物吊在尖端等错误

操作。起重链条应垂直悬挂,不得有错扭的链环,双行链的下吊

钩架不得翻转。

 

Checked before lifting the upper and lower hook is hanging in prison.

Weight suspended from the tip is strictly prohibited errors such operations.

Lifting chain should be hung vertically, without twisting the wrong link, double

chain hook frame shall turn next.

5.

操作者应站在与手链轮同一平面内拽动手链条,使手链轮

沿顺时针方向旋转,即可使重物上升;反向拽动手链条,重物即

可缓缓下降。

 

The operator should stand on the same plane with the bracelet round

hands pulled the chain, so that bracelet round clockwise, you can increase the

weight; reverse hands pulled the chain, you can slow down weight.

 

6.

在起吊重物时,严禁人员在重物下做任何工作或行走,以

免发生人身事故。

 

In lifting weights, strictly prohibited in any work under hea

vy objects or

walking in order to avoid injury.

7.

在起吊过程中,无论重物上升或下降,拽动手链条时,用

力应均匀和缓,不要用力过猛,以免手链条跳动或卡环。

 

In the lifting process, regardless of weight up or down, hands pulled the

chain, the force should be uniform gentle, not too much force, so as not to beat

or hand chain ring.

8.

操作者如发现手拉力大于正常拉力时,应立即停止使用。

防止手链条磨损。

 

Operator found hand pulling tension greater than normal, they should

immediately stop using. Hand chain to prevent wear and tear.

以上由杭州武林机器有限公司收集整理。

马上联系:0571-89266809

传真号码:0571-89266839

手机:15336598237

武林飞鸽品牌营销中心 © 版权所有 数据统计
网站备案 浙ICP备19050486号-25